– All “ServiceBip with 3 buttons” will be automatically considered.
– No specific programming.
Switch 1-OFF / Switch 2-OFF
– Only the “ServiceBip with 3 buttons” programmed according to the following procedure will be taken into account.
– No specific programming.
Save a ServiceBip™ (transmitter):
1 – Press and hold «SAVE KEY» until the led «SAVE» goes to slow blink, then release.
2 – Take a button and press once on «Bell» or «€» it will be automatically saved by the repeater. It emits a “beep” sound to confirm the registration button.
3 – Press «SAVE» once and repeat step no 2 for the following transmitter.
4 – Press and hold «SAVE KEY» for 5 seconds to exit.
Deletion of the ServiceBip™ (transmitter):
1 – Press and hold «DEL KEY» for 3 seconds until the indicator light flashes in slow mode, then release.
2 – Take a button and press once on «Bell» or «€» to remove the repeater.
3 – To delete all stored data, press and hold «DEL KEY» for 3 seconds then release. Press «DEL KEY» again for 5 seconds until the long sound occurs.
Switch 1-ON / Switch 2-ON
– All “ServiceBip with 1 button” will be automatically considered.
– No specific programming.
witch 1-OFF / Switch 2-OFF
– Only the “ServiceBip with 1 button” programmed according to the following procedure will be taken into account.
– No specific programming.
For ServiceBip™ Mono perform the same procedure as for ServiceBip™ (3 buttons) using the «only existing button» instead of «Bell» or «€».
